Recording a GEWA infrared code

  1. Choose Tools > GEWA > Record.
  2. Selecting an infrared code from the dialog GEWA
  3. In the Enter new name: field, enter the name of the infrared code.
    Television louder
  4. Hold the remote control of the relevant device (for example, the TV remote control) at a distance of approximately 5 cm from the device's infrared receiver (Smart, Tellus, Mobi, ...)
  5. Click Record.
    The Status field will display the message Press key and hold.
  6. Press the button of your remote control for the code you want the IR module to record (in this case the IR code for television volume up).
  7. Hold and press until the red light in the IR window switches off or until the Release key message appears in the Status field.
  8. Repeat the previous 2 steps to link the code a second time.
    The red lamp will flash briefly to confirm that the record procedure has been completed successfully. The Status field will display the message OK. If Error appears, repeat the procedure starting from step 5.
  9. Point your device (Smart, Tellus, Mobi, ...) towards the device of which you want to test the infrared code.
  10. Click Test.
    If the infrared code actually carries out the requested command, then the test is OK. If not, then the code needs to be recorded again.
  11. Repeat from step 2 to record more infrared codes.
  12. Click OK.