Training an infrared code

Your existing appliance that you have already added can be trained new infrared codes.

  1. Press and select Connectivity > Infrared.
  2. Select the appliance that you wish to train an infrared code.
    For example, TV living room
  3. Choose to train an infrared code.
  4. Enter the name of the infrared code.
    For example, Television louder.
  5. Confirm with .
  6. Hold the remote control of the appliance, for example, the TV remote control, at a distance of approximately 5 cm from the Allora 3's infrared receiver.
  7. Briefly press the remote control key that you want to train.
    The training process may be disrupted by other light sources nearby. Where applicable, shield the light receiver with your hand when training the infrared code.
  8. Point the Allora 3 towards the device of which you want to test the infrared code.
    The infrared signal is transmitted by the infrared transmitter on the back of the Allora 3.
    If the infrared code actually carries out the requested command, then the test is OK. If not, then the code needs to be recorded again.
  9. Repeat from step 2 to record more infrared codes.